Subject	90% certain it is lifters.
Posted by	TyTyIsFly27 on April 17, 2015 at 1:12 PM
	This message has been viewed 281 times.
In Reply To	Usually needs about 20min of running. posted by Woody75 (Denver) on April 17, 2015 at 12:21 PM
Message	It was honestly so loud when I first started it that I couldn't tell where it was coming from. It quieted down a bit after a few minutes, but is still incredibly loud. I could actually feel a little bit of the lifters "clacking" when I touched the intake valve cover about halfway back. All cam gears were from the same engine as the lifters, which sounded good when it last ran. I ran it up to temp, and took it for a spin down the street and back, thinking that it would get a bit better, but not much luck. Will run it a few more times before I pull it apart for sure then. Anything else I can try, other than just letting it run for a bit?
Follow Ups	New engine lifter noise - TyTyIsFly27 12:11:43 04/17/15 Usually needs about 20min of running. - Woody75 (Denver) 12:21:39 04/17/15 90% certain it is lifters. - TyTyIsFly27 13:12:17 04/17/15 no short cuts - EngineerLV 16:45:31 04/17/15 I used JWT HD springs - TyTyIsFly27 10:05:19 04/18/15 No expert here but the JWT springs aren't much stronger - flashstar 14:25:36 04/18/15 Re: New engine lifter noise - MaxxAction 20:57:51 04/17/15 Stock VTC gears. - TyTyIsFly27 10:09:18 04/18/15 Re: Stock VTC gears. - MaxxAction 12:44:32 04/18/15 Thanks for the info - TyTyIsFly27 15:28:36 04/18/15 I had it when I had my heads reworked. - z-u-later 14:16:25 04/18/15 This is a very possible cause for me... - TyTyIsFly27 15:31:02 04/18/15
Post a Followup	You cannot reply to this message because you are not logged in.