Subject	It's not my original idea. Others used electrical tape, so I
Posted by	Zuberman on April 13, 2015 at 1:47 PM
	This message has been viewed 298 times.
In Reply To	Thanks! I'll try this on the old differential when I finish posted by flashstar on April 13, 2015 at 01:30 PM
Message	will take credit for the metal tape part which I feel holds up better than electrical tape, especially against the heat. Thanks, and good luck :)
Follow Ups	Differential Backlash, Clunk-> Replace or Shim? - flashstar 00:04:19 04/12/15 Does your drain-plug have a head on it? Or is it a recessed - Zuberman 00:58:46 04/12/15 Recessed Square Drive. Long breaker bar stripped out the - flashstar 01:11:10 04/12/15 Can you post a close-up pic of the drain-plug? - Zuberman 02:10:52 04/12/15 Here's a picture! - flashstar 21:26:25 04/12/15 Try bolt out extractor - Ron(Houston) 22:16:26 04/12/15 WHEW! That's pretty bad. Here's what I had in mind.... - Zuberman 13:00:01 04/13/15 Thanks! I'll try this on the old differential when I finish - flashstar 13:30:22 04/13/15 It's not my original idea. Others used electrical tape, so I - Zuberman 13:47:11 04/13/15 I would use 1/8 thick flat steel cut to make a jamb fit >> - ZUL8TR 13:31:07 04/13/15 It turns out that some backlash was coming from my axles - flashstar 21:30:52 04/12/15 check the outer axel joint it is usually worse, post results (n/m) - ZUL8TR 13:13:27 04/13/15 Axial play sounds worse on outers. Inners have more radial - flashstar 13:28:44 04/13/15 Try this. Lock the tranny on gear rise both rears off the >> - ZUL8TR 13:48:17 04/13/15 Differential is now off car. I'll hold the half shaft - flashstar 14:21:39 04/13/15 A good comparison would be to check with a 1/2 shaft that >> - ZUL8TR 04:07:13 04/14/15 The O'Reilly's is a reman, although it's a MasterPro... - flashstar 12:15:17 04/14/15 The O'Reilly shafts have just as much play in them - flashstar 12:54:28 04/15/15 that eliminates one item from the search, keep us posted. (n/m) - ZUL8TR 04:18:49 04/16/15 Re: It turns out that some backlash was coming from my axles - slcZ32 12:46:47 04/14/15
Post a Followup	You cannot reply to this message because you are not logged in.