Subject	Are you working on an alignment rack?
Posted by	BlackholeZ on April 11, 2015 at 8:23 PM
	This message has been viewed 233 times.
In Reply To	I am using the stock bump steer setting (no adjustment) posted by flashstar on April 11, 2015 at 01:16 PM
Message	If not all your guessing is really useless. Get it close enough that you can get it aligned at an alignment shop. -Dan VTC Solenoid Caps and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Tie Rod Default Turns? - flashstar 01:27:26 04/11/15 Not really - aliaZ 07:30:26 04/11/15 I am using the stock bump steer setting (no adjustment) - flashstar 13:16:32 04/11/15 Are you working on an alignment rack? - BlackholeZ 20:23:59 04/11/15 I Plan to Use One of These Bump Steer Machines: - flashstar 20:40:02 04/11/15 This belongs in the tech forum. Though Im not sure - ForceFedTT (SoCal) 14:46:45 04/11/15 Stuff gets moved over (n/m) - BlackholeZ 20:21:42 04/11/15 Sorry, should have posted it there. Feel free to move (n/m) - flashstar 20:46:45 04/11/15 Re: Tie Rod Default Turns? - diamond20601 22:31:25 04/11/15 Thanks for the input. I have around 1"-1/16 of thread at - flashstar 23:22:01 04/12/15
Post a Followup	You cannot reply to this message because you are not logged in.