Subject	JWT POP Charger air-filter? I seem to recall rotating the
Posted by	Zuberman on April 07, 2015 at 4:39 PM
	This message has been viewed 262 times.
In Reply To	Dies After Revving (I've tried everything!) posted by Dragginz on April 07, 2015 at 11:16 AM
Message	T-pipe up or down remedied some issues. And I think there was a recommendation of putting a strip of duct-tape from tip to base on the air-filter, but I don't remember if the strip of duct-tape was supposed to go on the bottom of the air-filter or the top.
Follow Ups	Dies After Revving (I've tried everything!) - Dragginz 11:16:56 04/07/15 have a look at the tps, adjusted properly? (n/m) - itsa300zx 11:27:51 04/07/15 Re: have a look at the tps, adjusted properly? - Dragginz 12:05:39 04/07/15 Sounds like a Throttle Enrichment problem - Cjw3 13:17:06 04/07/15 Re: Sounds like a Throttle Enrichment problem - Dragginz 14:29:56 04/07/15 I'm not Turbo Orented.. So I wont answer Yes or No - Cjw3 15:10:06 04/07/15 Re: I'm not Turbo Orented.. So I wont answer Yes or No - Dragginz 17:25:30 04/07/15 Shopping List.. - Cjw3 20:38:37 04/07/15 Re: Shopping List.. - Dragginz 09:19:43 04/08/15 JWT POP Charger air-filter? I seem to recall rotating the - Zuberman 16:39:47 04/07/15 Re: JWT POP Charger air-filter? I seem to recall rotating the - Dragginz 17:27:57 04/07/15 Have exact same problem. - vice 23:58:25 04/07/15 Re: Have exact same problem. - Dragginz 09:21:51 04/08/15 That might be your problem. - vice 15:30:26 04/12/15 For what it's worth: I was having the same issues - ZTicket(Dallas) 05:56:02 04/08/15 Zticket, are you going to TMS this year to broadcast? (n/m) - puchy 07:23:43 04/08/15 As far as I know, Friday Night Drags at TMS are ON ! - ZTicket(Dallas) 09:41:43 04/08/15 Re: For what it's worth: I was having the same issues - Dragginz 08:58:21 04/08/15 You might be having electrical problems in the harness - ZTicket(Dallas) 09:54:06 04/08/15 Re: You might be having electrical problems in the harness - Dragginz 18:05:37 04/11/15 Re: You might be having electrical problems in the harness - Dragginz 18:07:46 04/11/15 Set your i idle controller at 900rpm (unpluged) - puchy 09:46:14 04/08/15 Re: Set your i idle controller at 900rpm (unpluged) - Dragginz 09:59:34 04/08/15 2nd this.. Set my idle to about 900rpm - Drk93TT 17:15:24 04/08/15 Provide more details on your dual POP setup - spicyZ 08:23:39 04/09/15 Re: Provide more details on your dual POP setup - Dragginz 09:24:14 04/09/15
Post a Followup	You cannot reply to this message because you are not logged in.