Subject	kinugawa wastegate - engine mount clearance
Posted by	irdhp on April 07, 2015 at 10:01 AM
	This message has been viewed 229 times.
Message	Replacing the the garret wastegate with kinugawa that I can change spring rate on. I have a problem with clearance on the right side. The wastegate is a bit to high/long. It bumbs into the engine mount. I need about 1cm in order to get the turbo on again. Is it possible to cut out a piece in order to get clearance enough? Will it still be safe to drive like that?
Follow Ups	kinugawa wastegate - engine mount clearance - irdhp 10:01:45 04/07/15 Re: kinugawa wastegate - engine mount clearance - Zuberman 16:44:48 04/07/15 Even with those you might get into the same problem. - kickerzx 12:50:08 04/09/15 Re: Even with those you might get into the same problem. - irdhp 03:03:53 04/10/15 I worked with SZ on this issue a long time ago - LitlElvis 15:03:49 04/11/15
Post a Followup	You cannot reply to this message because you are not logged in.