Subject	Looks pretty good. I had similar results on an original TT
Posted by	Tanley on April 02, 2015 at 12:24 AM
	This message has been viewed 220 times.
In Reply To	Leak Down Test results. I'm happy. Come burst my Bubble... posted by LivinTheDream on April 01, 2015 at 09:13 PM
Message	long block. #1 was my lowest at 11%. All the rest were between 6% and 9%. 120,000 miles. Did you give the tops of the valves a couple taps? I had to give a few taps on the exhaust valves to fully seat them, maybe a little carbon build up? You can hear a distinct hollow sound while tapping if they are not fully seated. Sound will change to a solid thud when they seal up. That can affect your numbers slightly.
Follow Ups	Leak Down Test results. I'm happy. Come burst my Bubble... - LivinTheDream 21:13:52 04/01/15 Looks pretty good. I had similar results on an original TT - Tanley 00:24:35 04/02/15 Did not know about the valve tap thing... - LivinTheDream 09:08:31 04/02/15 I used the JWT valve removal tool, it's basically - Tanley 14:36:01 04/02/15 have not replaced the seals yet and I do have the jwt tool. - LivinTheDream 16:20:35 04/02/15 Yeah don't clober it, just tap it. Make sure the cylinder is - Tanley 20:06:54 04/02/15 No luck on that one leaky intake valve :( - LivinTheDream 00:29:40 04/03/15 not to bad for a cold engine,I would expect less than 10% (n/m) - SammybTT(TN) 14:24:58 04/02/15 less than 10% for me when warm you mean? (n/m) - LivinTheDream 15:46:19 04/02/15 temperature makes little difference in my experience (n/m) - aliaZ 19:11:30 04/02/15 +1 (n/m) - Tanley 20:07:56 04/02/15
Post a Followup	You cannot reply to this message because you are not logged in.