you have to remove the whole pinion assembly. The rack can be pulled out the driver's side though. Un-do the rear tans mount and lift the trans, remove the line on the steering rack that goes to the far end. Disconnect the supply lines, steering shaft and the inner tie rods and pull it out. Then perform the rebuild procedure in the FAQ.
"Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
