Subject	Re-flow the pins at the connector
Posted by	BlackholeZ on March 31, 2015 at 12:10 AM
	This message has been viewed 253 times.
In Reply To	Brake Light Control Module posted by YlwPrlZTT on March 30, 2015 at 09:42 PM
Message	I had the same issue and even got a fix-it ticket for it. Fighting with 2 modules I was totally stumped. I could get them to turn on by wiggling the connector, I thought the pins in the connector were bad. All that pain in the ass, and then I opened it up and re-flowed the solder joints and it's been solid since. I couldn't see a break in the solder, but it was definitely not a solid connection. -Dan VTC Solenoid Caps and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Brake Light Control Module - YlwPrlZTT 21:42:42 03/30/15 All the light bulbs are good, I checked those. (n/m) - YlwPrlZTT 21:56:45 03/30/15 Re-flow the pins at the connector - BlackholeZ 00:10:57 03/31/15 I had to do the same (n/m) - aliaZ 11:39:46 03/31/15 Awesome, reflowing the solder fixed the issue with the old - YlwPrlZTT 19:30:23 03/31/15 :-) (n/m) - BlackholeZ 15:57:34 04/01/15
Post a Followup	You cannot reply to this message because you are not logged in.