Subject	Re: I’ve pulled a pan in place and pulled a dent w/ welder >>
Posted by	jhop1988 on March 29, 2015 at 3:21 PM
	This message has been viewed 200 times.
In Reply To	I’ve pulled a pan in place and pulled a dent w/ welder >> posted by my91z on March 28, 2015 at 02:40 PM
Message	Yea if I owned a welder I would of loved to tack weld the dent an pull it out. But I found the guide on dropping the pan. Kinda sketchy but knocked the dent out now I have bout 80 psi oil pressure an the lifter tick is gone. Thanks for all the advice
Follow Ups	low oil pressure dented oil pan - jhop1988 12:02:06 03/28/15 If it is dented then replace it or take it off and use a - Tanley 12:13:58 03/28/15 Re: If it is dented then replace it or take it off and use a - jhop1988 12:21:51 03/28/15 I’ve pulled a pan in place and pulled a dent w/ welder >> - my91z 14:40:44 03/28/15 Re: I’ve pulled a pan in place and pulled a dent w/ welder >> - jhop1988 15:21:59 03/29/15 Glad it worked out for you. (n/m) - my91z 17:27:55 03/29/15
Post a Followup	You cannot reply to this message because you are not logged in.