Subject	Re: Relicating knock sensor... M8-1.25 x 90mm Correct size ?
Posted by	nonstopna on March 18, 2015 at 4:38 PM
	This message has been viewed 175 times.
In Reply To	Relicating knock sensor... M8-1.25 x 90mm Correct size ? posted by nonstopna on March 18, 2015 at 12:07 AM
Message	What do u guys think of a 95mm hex bolt? I figured the head will seat on the top of the sensor nicely instead of the plastic and likely not bottom out. I'll have to measure once I get the bolt and post results and pics.
Follow Ups	Relicating knock sensor... M8-1.25 x 90mm Correct size ? - nonstopna 00:07:28 03/18/15 Use the 100mm.... - Zuberman 00:44:21 03/18/15 Unless you want to do the math of subtracting the nut in - Zuberman 00:50:29 03/18/15 Well ... I'll just go with the 100mm. - nonstopna 01:54:14 03/18/15 Re: Well ... I'll just go with the 100mm. - ttz'in (norcal) 01:57:23 03/18/15 Re: Well ... I'll just go with the 100mm. - Goldchocobo 12:48:24 03/18/15 2nd. I used my inch-lbs torque wrench to make sure I didn't - Zuberman 13:01:23 03/18/15 Re: Relicating knock sensor... M8-1.25 x 90mm Correct size ? - nonstopna 16:38:35 03/18/15 Sounds good.. (n/m) - ttz'in (norcal) 20:19:39 03/18/15
Post a Followup	You cannot reply to this message because you are not logged in.