Subject	Well ... I'll just go with the 100mm.
Posted by	nonstopna on March 18, 2015 at 1:54 AM
	This message has been viewed 184 times.
In Reply To	Unless you want to do the math of subtracting the nut in posted by Zuberman on March 18, 2015 at 12:50 AM
Message	The article does mention he could not find nothing in between so I gigured 90mm was optimal but now that i really look at it and measure the 90mm doesn't have the proper penetration which I think is critical for relocating this sensor.
Follow Ups	Relicating knock sensor... M8-1.25 x 90mm Correct size ? - nonstopna 00:07:28 03/18/15 Use the 100mm.... - Zuberman 00:44:21 03/18/15 Unless you want to do the math of subtracting the nut in - Zuberman 00:50:29 03/18/15 Well ... I'll just go with the 100mm. - nonstopna 01:54:14 03/18/15 Re: Well ... I'll just go with the 100mm. - ttz'in (norcal) 01:57:23 03/18/15 Re: Well ... I'll just go with the 100mm. - Goldchocobo 12:48:24 03/18/15 2nd. I used my inch-lbs torque wrench to make sure I didn't - Zuberman 13:01:23 03/18/15 Re: Relicating knock sensor... M8-1.25 x 90mm Correct size ? - nonstopna 16:38:35 03/18/15 Sounds good.. (n/m) - ttz'in (norcal) 20:19:39 03/18/15
Post a Followup	You cannot reply to this message because you are not logged in.