Subject	Unless you want to do the math of subtracting the nut in
Posted by	Zuberman on March 18, 2015 at 12:50 AM
	This message has been viewed 182 times.
In Reply To	Use the 100mm.... posted by Zuberman on March 18, 2015 at 12:44 AM
Message	millimeters and then re-configure the stack and use whichever metric length bolt? Nah, just use the 100mm. It'll be fine.
Follow Ups	Relicating knock sensor... M8-1.25 x 90mm Correct size ? - nonstopna 00:07:28 03/18/15 Use the 100mm.... - Zuberman 00:44:21 03/18/15 Unless you want to do the math of subtracting the nut in - Zuberman 00:50:29 03/18/15 Well ... I'll just go with the 100mm. - nonstopna 01:54:14 03/18/15 Re: Well ... I'll just go with the 100mm. - ttz'in (norcal) 01:57:23 03/18/15 Re: Well ... I'll just go with the 100mm. - Goldchocobo 12:48:24 03/18/15 2nd. I used my inch-lbs torque wrench to make sure I didn't - Zuberman 13:01:23 03/18/15 Re: Relicating knock sensor... M8-1.25 x 90mm Correct size ? - nonstopna 16:38:35 03/18/15 Sounds good.. (n/m) - ttz'in (norcal) 20:19:39 03/18/15
Post a Followup	You cannot reply to this message because you are not logged in.