TwinTurbo.NET: Nissan 300ZX forum - Had it pulled out yesterday and welded up the crack along
Subject
Had it pulled out yesterday and welded up the crack along
Posted by
rcmadness
on March 17, 2015 at 10:54 AM
This message has been viewed
173
times.
In Reply To
A-HA! So it is the bracket! Diagnosis is always the worst
posted by Zuberman
on March 12, 2015 at 11:02 PM
Message
with some reinforcement. Feels good again. This thing must have an aftermarket clutch in it because the spring is super stiff, stiffer than any other I've drove which is probably a contributing factor for the pedal bracket failure.
Follow Ups
Firewall flexing at clutch master cylinder
-
rcmadness
10:54:29 02/28/15
Is the top bolt in place that holds the bracket ? (n/m)
-
Bernie (NoVA)
11:22:14 02/28/15
I can see the bolt head is there but is there a nut on the
-
rcmadness
12:12:08 02/28/15
Trapped nut. (n/m)
-
Bernie (NoVA)
19:21:30 02/28/15
Re: Firewall flexing at clutch master cylinder
-
Konigg
12:13:03 02/28/15
In the 4th photo down in that article you will see the
-
rcmadness
12:31:18 02/28/15
Re: In the 4th photo down in that article you will see the
-
Konigg
16:22:12 02/28/15
Re: Firewall flexing at clutch master cylinder
-
Konigg
12:15:20 02/28/15
I know how to adjust the clutch and the switch is all the
-
rcmadness
12:24:38 02/28/15
I would imagine you would have noticed by now, but is the
-
davidztt
16:59:19 02/28/15
Found it...
-
rcmadness
17:44:40 03/11/15
A-HA! So it is the bracket! Diagnosis is always the worst
-
Zuberman
23:02:05 03/12/15
Had it pulled out yesterday and welded up the crack along -
rcmadness
10:54:43 03/17/15
Post a
Followup
You cannot reply to this message because you are not
logged in
.