Subject	Well if you have the plenum off that helps a lot
Posted by	BlackholeZ on March 16, 2015 at 10:52 PM
	This message has been viewed 313 times.
In Reply To	I do have my plenum off as well as my valve covers. posted by Zuberman on March 16, 2015 at 10:37 PM
Message	Last time I succeeded I was doing a 740 install at the same time and it wasn't too much of a hassle, but I've worked on a lot of these. I also have a 13mm open end that I've cut in half to make it easier to turn the bolts, but that only works if they're loose and spin pretty freely. Unbolting the rear trans mount and lifting will definitely give you some more space. Give that a try. -Dan VTC Solenoid Caps and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	I'm stuck. Please help. How do I get the first set of - Zuberman 11:13:19 03/16/15 Re: I'm stuck. Please help. How do I get the first set of - Goldchocobo 11:46:06 03/16/15 Do you go after it from underneath the car or from above - Zuberman 12:29:57 03/16/15 Underneath - Goldchocobo 12:52:13 03/16/15 Do you mean precats, AKA downpipes? - Goldchocobo 13:55:48 03/16/15 Engine, Turbos, catalytic-converters: those ones. The ones - Zuberman 15:21:27 03/16/15 Re: Engine, Turbos, catalytic-converters: those ones. The ones - ttz'in (norcal) 15:54:40 03/16/15 Part# 14440 and 14440+A (n/m) - Zuberman 16:38:48 03/16/15 Yes sir,..Think Z1 still offers a buy back program. (n/m) - ttz'in (norcal) 16:45:51 03/16/15 I think we missed each other somewhere, but I may just offer - Zuberman 17:01:08 03/16/15 Re: I think we missed each other somewhere, but I may just offer - ttz'in (norcal) 17:06:23 03/16/15 If you mean the pre-cats, it's not impossible, just - ttz'in (norcal) 13:16:12 03/16/15 Does removing the aluminum heat shields from the cats give - Zuberman 16:59:06 03/16/15 Re: Does removing the aluminum heat shields from the cats give - ttz'in (norcal) 17:04:00 03/16/15 I mean if I remove the aluminum heat shields from the pre- - Zuberman 21:54:43 03/16/15 Re: I mean if I remove the aluminum heat shields from the pre- - ttz'in (norcal) 22:17:36 03/16/15 Yes, I always pull the heat shields - BlackholeZ 22:25:39 03/16/15 ^ Agree ^ (n/m) - ttz'in (norcal) 22:29:51 03/16/15 It's a pain - BlackholeZ 22:21:59 03/16/15 I do have my plenum off as well as my valve covers. - Zuberman 22:37:28 03/16/15 Well if you have the plenum off that helps a lot - BlackholeZ 22:52:37 03/16/15 VIDEO, driver-side: I see one pre-cat bolt on top that I - Zuberman 23:44:51 03/16/15 Removing precats with tranny still in... - 240Z FeO2 00:54:44 03/17/15 The 4th is inboard (towards the motor) - BlackholeZ 01:19:31 03/17/15 Not sure if anyone is interested but the pre-cats are off. - Zuberman 21:19:14 03/19/15
Post a Followup	You cannot reply to this message because you are not logged in.