Subject	Found it...
Posted by	rcmadness on March 11, 2015 at 5:44 PM
	This message has been viewed 196 times.
In Reply To	Firewall flexing at clutch master cylinder posted by rcmadness on February 28, 2015 at 10:54 AM
Message	but haven't fixed it. I used my snap on camera to probe through the firewall. I put the camera in the hole where the twin turbo vacuum assisted hose nipple would have been above the reservoir and found a huge crack in the clutch pedal bracket. When pulling up on the clutch pedal, the crack widens by what looks like three quarters of an inch and spans 80% of the brackets width. I've yet to find time to pull it apart.
Follow Ups	Firewall flexing at clutch master cylinder - rcmadness 10:54:29 02/28/15 Is the top bolt in place that holds the bracket ? (n/m) - Bernie (NoVA) 11:22:14 02/28/15 I can see the bolt head is there but is there a nut on the - rcmadness 12:12:08 02/28/15 Trapped nut. (n/m) - Bernie (NoVA) 19:21:30 02/28/15 Re: Firewall flexing at clutch master cylinder - Konigg 12:13:03 02/28/15 In the 4th photo down in that article you will see the - rcmadness 12:31:18 02/28/15 Re: In the 4th photo down in that article you will see the - Konigg 16:22:12 02/28/15 Re: Firewall flexing at clutch master cylinder - Konigg 12:15:20 02/28/15 I know how to adjust the clutch and the switch is all the - rcmadness 12:24:38 02/28/15 I would imagine you would have noticed by now, but is the - davidztt 16:59:19 02/28/15 Found it... - rcmadness 17:44:40 03/11/15 A-HA! So it is the bracket! Diagnosis is always the worst - Zuberman 23:02:05 03/12/15 Had it pulled out yesterday and welded up the crack along - rcmadness 10:54:43 03/17/15
Post a Followup	You cannot reply to this message because you are not logged in.