Subject	this shows what I did to put my amp in the wheel well
Posted by	not4resaleZ on March 10, 2015 at 2:08 PM
	This message has been viewed 223 times.
In Reply To	Looking for ideas on spare tire well modification... posted by JMartz on March 09, 2015 at 11:06 AM
Message	Did not drill any holes in the car, used the existing tire hold down "horn" and the inflation canister hoop to hold it down. Using a steel plate over the "horn" allowed the base of the amp to be about 1/4" from the top of the "horn". The kerf bent wood mimics the wheel. Large pizza pan used to span over kerf bent wood. [ http://www.twinturbo.net/nissan/300zx/forums/general/view/2296518/Here-are-some-pictures-hope-this-works--I-didnt-take.html ]
Follow Ups	Looking for ideas on spare tire well modification... - JMartz 11:06:16 03/09/15 I cut up wooden pegs and secured them to the bottom. - Woody75 (Denver) 12:12:43 03/09/15 Re: Looking for ideas on spare tire well modification... - ZTom 12:16:05 03/09/15 warning.. do not use that spare - Cjw3 13:30:39 03/09/15 No worries.. - JMartz 14:14:56 03/09/15 Re: warning.. do not use that spare - Ted (92TT) 19:35:19 03/09/15 Re: warning.. do not use that spare - Bad Fish 17:48:33 03/10/15 Here are just a few I found in a short hunt - Cjw3 20:23:10 03/10/15 Re: Here are just a few I found in a short hunt - Bad Fish 09:05:30 03/11/15 this shows what I did to put my amp in the wheel well - not4resaleZ 14:08:50 03/10/15 Re: this shows what I did to put my amp in the wheel well - Hiram 07:12:19 03/13/15
Post a Followup	You cannot reply to this message because you are not logged in.