Subject	I would imagine you would have noticed by now, but is the
Posted by	davidztt on February 28, 2015 at 4:59 PM
	This message has been viewed 221 times.
In Reply To	I know how to adjust the clutch and the switch is all the posted by rcmadness on February 28, 2015 at 12:24 PM
Message	firewall rusted inside or outside at the location of the clutch master-cylinder hole going through the firewall? That hydraulic-fluid is very corrosive. Maybe loosen the clutch master-cylinder and take a peek at that hole on both sides of the firewall? Also maybe check your pedal bracket to see if it might be cracked. Apparently, cracking at the point of that hole does happen.
Follow Ups	Firewall flexing at clutch master cylinder - rcmadness 10:54:29 02/28/15 Is the top bolt in place that holds the bracket ? (n/m) - Bernie (NoVA) 11:22:14 02/28/15 I can see the bolt head is there but is there a nut on the - rcmadness 12:12:08 02/28/15 Trapped nut. (n/m) - Bernie (NoVA) 19:21:30 02/28/15 Re: Firewall flexing at clutch master cylinder - Konigg 12:13:03 02/28/15 In the 4th photo down in that article you will see the - rcmadness 12:31:18 02/28/15 Re: In the 4th photo down in that article you will see the - Konigg 16:22:12 02/28/15 Re: Firewall flexing at clutch master cylinder - Konigg 12:15:20 02/28/15 I know how to adjust the clutch and the switch is all the - rcmadness 12:24:38 02/28/15 I would imagine you would have noticed by now, but is the - davidztt 16:59:19 02/28/15 Found it... - rcmadness 17:44:40 03/11/15 A-HA! So it is the bracket! Diagnosis is always the worst - Zuberman 23:02:05 03/12/15 Had it pulled out yesterday and welded up the crack along - rcmadness 10:54:43 03/17/15
Post a Followup	You cannot reply to this message because you are not logged in.