Subject	i would recommend using solder joint over a butt connection
Posted by	SammybTT(TN) on February 28, 2015 at 9:01 AM
	This message has been viewed 203 times.
In Reply To	size of knock sensor wire ecu side? (n/m) posted by msb1987 on February 27, 2015 at 06:25 PM
Message	I am not sure of the wire gauge size. Can you cut off a small section of the un-damaged wire and take it with you when you buy the replacement wire? The vendor should be able to help you find the correct gauge (AWG)
Follow Ups	size of knock sensor wire ecu side? (n/m) - msb1987 18:25:57 02/27/15 Re: size of knock sensor wire ecu side? - ZTom 20:53:19 02/27/15 Thickness, gauge. I need to remove a damaged section and - msb1987 23:40:12 02/27/15 i would recommend using solder joint over a butt connection - SammybTT(TN) 09:01:33 02/28/15 In the EFI harness? - -Grimm- 09:47:00 02/28/15 I just went through this with my Toyota pickup: UGH! - davidztt 16:43:48 02/28/15
Post a Followup	You cannot reply to this message because you are not logged in.