Subject	If you have to reverse the shifter to get the needed >>
Posted by	ZUL8TR on February 25, 2015 at 5:04 AM
	This message has been viewed 207 times.
In Reply To	Shifter Fitment Clearance to Radio/Clock Bezel posted by titotonto on February 23, 2015 at 12:24 PM
Message	clearance you should consider replacing the 2 plastic bushings in the shifter, they wear out and give a loose feel to the shifter. If you do the replacement it can be done topside, grease them well with #2 bearing grease. Bushings are a push in but require some force to final position. The pass thru bolt is easy to get back in from passenger side but the nut on the bolt on the drivers side is a pain to start. I temp glue the nut (contact cement or weather strip adhesive) to my left hand pointer finger and place it on the bolt and turn the bolt with a small ratchet. ZUL8TR in Orlando,FL
Follow Ups	Shifter Fitment Clearance to Radio/Clock Bezel - titotonto 12:24:35 02/23/15 Have you tried turning your shifter around - -Grimm- 12:29:54 02/23/15 remove the shifter leather boot and look at the top - itsa300zx 15:19:08 02/23/15 Re: remove the shifter leather boot and look at the top - titotonto 16:00:29 02/23/15 I always find it very satisfying everytime I correct - ZXoltan 18:18:48 02/23/15 My 2+2 NA has the same issue - Cjw3 20:12:46 02/23/15 Stock shifter has a bend in it. - Woody75 (Denver) 09:38:22 02/24/15 If you have to reverse the shifter to get the needed >> - ZUL8TR 05:04:11 02/25/15 Re: If you have to reverse the shifter to get the needed >> - titotonto 19:12:35 02/28/15 Re: Re: If you have to reverse the shifter to get the needed >> - titotonto 19:14:20 02/28/15 Re: Re: Re: If you have to reverse the shifter to get the needed >> - titotonto 19:32:31 02/28/15 yep, mounted backwards in the shift linkage (n/m) - itsa300zx 21:45:49 02/28/15 Shifter info on bushing replace and other - ZUL8TR 03:51:58 03/01/15
Post a Followup	You cannot reply to this message because you are not logged in.