Subject	Re: Re: Inner tide rod socket size
Posted by	ttz'in (norcal) on February 20, 2015 at 2:15 AM
	This message has been viewed 162 times.
In Reply To	Re: Inner tide rod socket size posted by Metacom on February 19, 2015 at 02:57 PM
Message	Open end wrench with a little persuasion from a ball peen or dead blow if needed. Locking plates came with new ends, but if old plates are gently removed (ie: bent back),I suppose you could reuse them. Either way pay attention to tabs on bottom that line up with groove in rod end. Be sure not to lose spacer washer.
Follow Ups	Inner tide rod socket size - Metacom 12:08:31 02/19/15 32mm, or 1 1/4" - ttz'in (norcal) 12:58:47 02/19/15 thanks (n/m) - Metacom 13:41:30 02/19/15 Re: Inner tide rod socket size - Metacom 14:57:44 02/19/15 Re: Re: Inner tide rod socket size - ttz'in (norcal) 02:15:38 02/20/15
Post a Followup	You cannot reply to this message because you are not logged in.