Subject	Re: My 40P heads dont have anything stamped there
Posted by	wh0sjeff on February 10, 2015 at 2:41 PM
	This message has been viewed 187 times.
In Reply To	My 40P heads dont have anything stamped there (n/m) posted by -Grimm- on February 10, 2015 at 11:34 AM
Message	im not sure if tat eases my mind or raises more question. also, I eas never aware that any milling equipment measured more than .001 of an inch. maybe im wrong. thanks for your input though 1
Follow Ups	cylinder head question - wh0sjeff 02:49:27 02/10/15 My 40P heads dont have anything stamped there (n/m) - -Grimm- 11:34:04 02/10/15 Re: My 40P heads dont have anything stamped there - wh0sjeff 14:41:32 02/10/15 All the bridgeports Ive used measure 0.001 incremenets - -Grimm- 19:20:03 02/10/15
Post a Followup	You cannot reply to this message because you are not logged in.