Subject	dummy maf replacement with smoother transition?
Posted by	mizzuh on September 29, 2014 at 11:59 PM
	This message has been viewed 459 times.
Message	I have been contemplating a way to have a machine shop fab me up a set of transitional channels to replace the stock vortex plate/dummy maf plates for my intakes. i am running a haltech PNP with no more mafs, therefore I have 2 dummy mafs installed A transitional "cone" that starts from the diameter of the pop chargers down to the diameter of the inlet pipes would be more efficient, as oppose to vortex plates and maf adapters a transitional reduction channel would decrease internal flow turbulence, as oppose to the plates and adapters that immediately cut the 4 inch filter size down to a 2.5 here's what I'm thinking instead of this: any thoughts?
Follow Ups	dummy maf replacement with smoother transition? - mizzuh 23:59:15 09/29/14 Like these? - ttsmokin 10:13:07 09/30/14
Post a Followup	You cannot reply to this message because you are not logged in.