TwinTurbo.NET: Nissan 300ZX forum - Checked with a machined straight edge? (n/m)
Subject
Checked with a machined straight edge? (n/m)
Posted by
ttsmokin
on September 16, 2014 at 1:23 PM
This message has been viewed
136
times.
In Reply To
Re: Did you have any work done to the block?
posted by Snake9289
on September 16, 2014 at 10:10 AM
Message
Follow Ups
headgasket leak after 15min rebuild
-
Snake9289
07:31:42 09/16/14
I cant believe you missed anything during a 15minute rebuild
-
whamo
09:42:37 09/16/14
Did you have any work done to the block?
-
-Grimm-
09:51:30 09/16/14
Re: Did you have any work done to the block?
-
Snake9289
10:10:16 09/16/14
Checked with a machined straight edge? (n/m) -
ttsmokin
13:23:43 09/16/14
Your over thinking this. A blocked port isnt going to cause
-
whamo
14:26:04 09/16/14
No, plus it isnt the only port, so the coolant
-
-Grimm-
15:28:07 09/16/14
Post a
Followup
You cannot reply to this message because you are not
logged in
.