Subject	I believe you are correct but don't understand why it
Posted by	SammybTT(TN) on August 11, 2014 at 7:05 PM
	This message has been viewed 206 times.
In Reply To	Timing loop should be on the PTU harness. posted by -Grimm- on August 11, 2014 at 06:47 PM
Message	is looped like it is as it appears to be the original condition and I don't want to disturb it if it is a testing loop. I believe it goes to the center pin of the coil pack connectors and the F23 wire that comes from the IGN relay via the E10 connector. I want to cut this wire and then trace it out to determine the origination and final destination but thought I would ask the experts on here if they have any experience with this. Guess I will double check the wiring one more time before I cut and tap into this wire. The main reason for this wire as it is easier to access than trying to locate the same wire underneath the relay blocks. If push comes to shove and no one can tell me it will be cut (live and learn) lol
Follow Ups	What the heck is this wire loop for? - SammybTT(TN) 15:21:59 08/11/14 Is that the timing loop? (n/m) - JMartz 17:57:47 08/11/14 Timing loop should be on the PTU harness. - -Grimm- 18:47:17 08/11/14 I believe you are correct but don't understand why it - SammybTT(TN) 19:05:44 08/11/14 I've got the same loop an thought it was for timing. - xpwarrior 22:27:11 08/11/14 Thanks for the reply Jason - SammybTT(TN) 07:21:41 08/12/14 What are you moving? (n/m) - -Grimm- 10:01:18 08/12/14 i have decided to put the 2 step controller inside - SammybTT(TN) 15:07:20 08/12/14 Oh, very nice! - -Grimm- 20:48:09 08/12/14 purchased from a fellow member on this forum Nismoboost 31 - SammybTT(TN) 19:49:03 08/13/14 Ah that box... - -Grimm- 14:57:08 08/14/14 Doesn't cutting fuel risk detonation? (n/m) - SammybTT(TN) 22:02:05 08/14/14 Only if done improperly - -Grimm- 09:41:03 08/15/14 My OEM harness has that as well - BlackholeZ 20:01:29 08/12/14 Thanks, I'll post the final wiring soon (I hope) lol (n/m) - SammybTT(TN) 19:50:44 08/13/14
Post a Followup	You cannot reply to this message because you are not logged in.