Subject	Only Whiteline makes fuca bushings I think. I may advise
Posted by	LivinTheDream on July 05, 2014 at 9:51 AM
	This message has been viewed 137 times.
In Reply To	fuca bushings posted by JP L. on July 04, 2014 at 01:21 PM
Message	Against this mod. The bushings don't fit all the way in. They are roughly 1/16 -1/8" to long. Im not sure how much this matters but i had to shave the exposed bushing so they may fit. This is after flexing the upright arm open a bit with a jack. Maybe they were made mainly for the skyline arm and the arm could be slightly different. Also you would want to sand the inside of the fuca before u attempt to install these as they are a really really really tight fit. "torque gets you off the line...& hp gets you over the line." - TTKeeper
Follow Ups	fuca bushings - JP L. 13:21:40 07/04/14 Only Whiteline makes fuca bushings I think. I may advise - LivinTheDream 09:51:38 07/05/14 Re: fuca bushings - Rob260 07:35:23 07/08/14
Post a Followup	You cannot reply to this message because you are not logged in.