Subject	wow... I hope it doesnt come to that. fingers crossed.
Posted by	Zbullet on June 25, 2014 at 4:50 PM
	This message has been viewed 261 times.
In Reply To	I had the same issue with two aftermarket 1-piece posted by Evan_Wright (Ca) on June 25, 2014 at 12:48 PM
Message	My DS is carbon fiber and not cheap so I hope the splines are good. Being relatively new and with indoor storage it'd be hard to believe its rusted. I'll go to town with the rubber mallet again.
Follow Ups	Driveshaft is STUCK - Suggestions???? - Zbullet 19:20:03 06/24/14 Maybe try lowering or raising the trans (n/m) - BarryGZX 20:08:03 06/24/14 Sounds like you are on the right track - SammybTT(TN) 21:32:29 06/24/14 unfortunately i cant get a pry bar in yet... - Zbullet 07:06:44 06/25/14 Ok, I have a couple of pry bars / alignment tools that would - SammybTT(TN) 11:56:24 06/25/14 Input shaft is probably frozen to the trans output - -Grimm- 09:30:30 06/25/14 Get a mallet and pound on it. (n/m) - ZaXxon 10:48:00 06/25/14 I had the same issue with two aftermarket 1-piece - Evan_Wright (Ca) 12:48:06 06/25/14 wow... I hope it doesnt come to that. fingers crossed. - Zbullet 16:50:51 06/25/14 Try removing the front diff bushing bolts and lowering - TriniTT 14:09:27 06/25/14
Post a Followup	You cannot reply to this message because you are not logged in.