Subject	Input shaft is probably frozen to the trans output
Posted by	-Grimm- on June 25, 2014 at 9:30 AM
	This message has been viewed 232 times.
In Reply To	Driveshaft is STUCK - Suggestions???? posted by Zbullet on June 24, 2014 at 07:20 PM
Message	most likely some rust, not bent splines. Have you tried tapping the input shaft perpendicular to the trans, right on the yolk? I would use a deadblow hammer, try to break free the bond without damaging anything. ------------------------------------------------------------------ 1992 300ZX NA 5 Sp (Dead) 1990 300ZX NA Auto 2+2 (Dead) 1990 300ZX TT 5 Sp (Building) 2004 G35 Sport 6MT (DD)
Follow Ups	Driveshaft is STUCK - Suggestions???? - Zbullet 19:20:03 06/24/14 Maybe try lowering or raising the trans (n/m) - BarryGZX 20:08:03 06/24/14 Sounds like you are on the right track - SammybTT(TN) 21:32:29 06/24/14 unfortunately i cant get a pry bar in yet... - Zbullet 07:06:44 06/25/14 Ok, I have a couple of pry bars / alignment tools that would - SammybTT(TN) 11:56:24 06/25/14 Input shaft is probably frozen to the trans output - -Grimm- 09:30:30 06/25/14 Get a mallet and pound on it. (n/m) - ZaXxon 10:48:00 06/25/14 I had the same issue with two aftermarket 1-piece - Evan_Wright (Ca) 12:48:06 06/25/14 wow... I hope it doesnt come to that. fingers crossed. - Zbullet 16:50:51 06/25/14 Try removing the front diff bushing bolts and lowering - TriniTT 14:09:27 06/25/14
Post a Followup	You cannot reply to this message because you are not logged in.