Subject	unfortunately i cant get a pry bar in yet...
Posted by	Zbullet on June 25, 2014 at 7:06 AM
	This message has been viewed 269 times.
In Reply To	Sounds like you are on the right track posted by SammybTT(TN) on June 24, 2014 at 09:32 PM
Message	I'm using the two notches in the diff flange to pry the ds mating connection. Unfortunately those notches aren't very wide.
Follow Ups	Driveshaft is STUCK - Suggestions???? - Zbullet 19:20:03 06/24/14 Maybe try lowering or raising the trans (n/m) - BarryGZX 20:08:03 06/24/14 Sounds like you are on the right track - SammybTT(TN) 21:32:29 06/24/14 unfortunately i cant get a pry bar in yet... - Zbullet 07:06:44 06/25/14 Ok, I have a couple of pry bars / alignment tools that would - SammybTT(TN) 11:56:24 06/25/14 Input shaft is probably frozen to the trans output - -Grimm- 09:30:30 06/25/14 Get a mallet and pound on it. (n/m) - ZaXxon 10:48:00 06/25/14 I had the same issue with two aftermarket 1-piece - Evan_Wright (Ca) 12:48:06 06/25/14 wow... I hope it doesnt come to that. fingers crossed. - Zbullet 16:50:51 06/25/14 Try removing the front diff bushing bolts and lowering - TriniTT 14:09:27 06/25/14
Post a Followup	You cannot reply to this message because you are not logged in.