Subject	Injector question
Posted by	Hatchet502 on June 15, 2014 at 5:09 PM
	This message has been viewed 161 times.
Message	I just replaced a couple stock old style injectors and on one of them I torqued down the cap and it spec'd out at 45O, far for the 12O it tested before I put it in. I pulled it and it was back at 12O and when I pushed on a certain spot on the top of the injector the rating would jump around. Then I put it back in it spec'd out just fine. Anyone else experience this before?
Follow Ups	Injector question - Hatchet502 17:09:41 06/15/14 I haven't had an experience like that but it sounds like - SammybTT(TN) 09:35:40 06/16/14 When you say 120 do you mean 12 ohms? Did you put >>> - ZUL8TR 10:35:08 06/19/14
Post a Followup	You cannot reply to this message because you are not logged in.