Subject	Sounds like the Valve Stems were not shortened enough
Posted by	Cjw3 on June 09, 2014 at 8:19 PM
	This message has been viewed 226 times.
In Reply To	New motor, need input on multiple issues. Overpumped Lifters posted by coreymbassett on June 09, 2014 at 08:12 PM
Message	I'd also see if you can Push Down the lifters on #1 & 3 then see if you can get a feeler gauge under them.. I think the heads need to come back off, and the Valve stems checked for length after the seat grind.. Cj
Follow Ups	New motor, need input on multiple issues. Overpumped Lifters - coreymbassett 20:12:07 06/09/14 Re: New motor, need input on multiple issues. Overpumped Lifters - coreymbassett 20:15:52 06/09/14 Sounds like the Valve Stems were not shortened enough - Cjw3 20:19:11 06/09/14 Agreed - check valve stem length to see how far the valves - LitlElvis 07:06:29 06/10/14 valve stem height out of spec will cause that - aliaZ 12:04:26 06/10/14 are your 400+ cams legit? - aliaZ 12:27:05 06/10/14
Post a Followup	You cannot reply to this message because you are not logged in.