Subject	Then set the Converter for Add and Try Again..
Posted by	Cjw3 on May 24, 2014 at 11:29 AM
	This message has been viewed 176 times.
In Reply To	Re: Re: Remove and Re-Insert the Prom.. posted by fastrnu90 on May 24, 2014 at 10:56 AM
Message	ZIF is a Zero Insertion Force socket.. It allows the Chip to be placed in the socket, then you move a handle to clamp the legs tight.. Normally it's used in the Prom Programmer. Sometimes they can be rather large.. I found one that fits nicely in the 300 ECU board.. Its for when your changing chips a lot.. But they are only $10 for a ZIF.. a Normal Socket is about $2.. Depending upon Quality.. Cj
Follow Ups	Eprom swap problem - fastrnu90 20:24:38 05/23/14 Remove and Re-Insert the Prom.. - Cjw3 22:29:57 05/23/14 Re: Remove and Re-Insert the Prom.. - fastrnu90 09:16:27 05/24/14 Re: Re: Remove and Re-Insert the Prom.. - fastrnu90 10:56:33 05/24/14 Then set the Converter for Add and Try Again.. - Cjw3 11:29:02 05/24/14 Your translator is set to ADD - Greg D. (Specialty-Z) 12:15:42 05/24/14 It's only got 3 positions..Add,Average, Multiply - Cjw3 14:33:19 05/24/14 In-Correct - Greg D. (Specialty-Z) 15:24:31 05/24/14 Re: In-Correct - fastrnu90 15:35:41 05/24/14 Then which 'Unit' has the 3 Setting Switch? (n/m) - Cjw3 16:39:19 05/24/14 Why did I wait so long?! - fastrnu90 22:27:40 05/24/14
Post a Followup	You cannot reply to this message because you are not logged in.