Hey thanks for the response when I change the other side I will try those 3/4 rods. But this time I went with the heat gun for roughly 1min on one side of the kingpin housing and the steering knuckle. And banged it about six times and it came loose. FINALLY! But its not over yet I know. I've already gashed that ball joint boot right below that ball seat in the transverse link right below the steering knuckle assy. in the pic. Some grease came out. I suppose I'm going to have to fix that. Tried to get the wheel bearing lock nut off today. No luck broke the extension to the 1-1/4 socket I was using. I was questioning whether the thing is suppose to come off.
22:04:14 05/16/14
