Subject	^I agree
Posted by	-Grimm- on May 15, 2014 at 1:42 PM
	This message has been viewed 262 times.
In Reply To	Lets look at the Selin.. posted by Cjw3 on May 15, 2014 at 01:24 PM
Message	If you have your MAF's in parallel (one on each bank) you need to add the signals, not average. If you average it you are sending your ECU the signal equivalent to about half of your engine displacement ------------------------------------------------------------------ 1992 300ZX NA 5 Sp (Dead) 1990 300ZX NA Auto 2+2 (Dead) 1990 300ZX TT 5 Sp (Building) 2004 G35 Sport 6MT (DD)
Follow Ups	lean condition..... help - poorkid_Z 02:12:47 05/15/14 Lets look at the Selin.. - Cjw3 13:24:39 05/15/14 ^I agree - -Grimm- 13:42:42 05/15/14 Re: ^I agree - poorkid_Z 14:25:08 05/15/14 The MAF Sig is used for Engine Load Calks - Cjw3 15:32:55 05/15/14 The advice your getting is poor..... - Greg D. (Specialty-Z) 20:14:32 05/15/14
Post a Followup	You cannot reply to this message because you are not logged in.