Subject	my Z must have an abnormal quirk then
Posted by	Zvil (FL) on May 05, 2014 at 4:52 PM
	This message has been viewed 400 times.
In Reply To	Idle is ALWAYS in Open Loop.. Read the Book (n/m) posted by Cjw3 on May 04, 2014 at 04:39 PM
Message	because my driver's side o2 is lazy, when I brought my Z to Harry it had an occasional miss due to running too lean at idle. Harry said he could tell the ecu to stop reading closed loop at idle, I opted out because I've grown fond of the miss.... it almost sounds like it's cammed. The miss only comes after my z has sat at idle for a long while, supposedly the fuel trims are leaned after getting feedback from idle. ____________________________________________________ "The dreaded 2nd windshiled wiper swipe when you turn it off its almost like tis showing you that it's boss, and it doesn't have to stop when you tell it to :("-College Boy (discussion on ptu relocation) "No good reason to put it there anyway. -Bernie (NoVA) False -vorpalZ False. -Bernie (NoVA) You're correct, there are 3 good reasons -vorpalZ False. -Bernie (NoVA) Wow, right again, just remembered another, make that 4 -vorpalZ" XD
Follow Ups	The most frustrating and elusive idle problem ever - Silens 13:05:58 05/01/14 What kind of intake do you have? Stock, JWT, etc. (n/m) - SirpriZ 15:45:14 05/01/14 Just stock with a filter, no airbox. (n/m) - Silens 16:46:11 05/01/14 Does your set up use a low speed drivability hose? (n/m) - SirpriZ 17:15:32 05/01/14 Not that I'm aware of. - Silens 17:22:57 05/01/14 The problem that I had in mind would only occur if you have - SirpriZ 17:23:38 05/01/14 nope, I wish lol. - Silens 17:45:10 05/01/14 Sounds like either the throttle plates are too far closed, - Greg D. (Specialty-Z) 18:16:48 05/01/14 Re: Sounds like either the throttle plates are too far closed, - Silens 12:04:15 05/02/14 PCV system ok? (n/m) - BarryGZX 19:25:37 05/01/14 Re: PCV system ok? - Silens 12:04:51 05/02/14 You say Wideband.. Only One? - Cjw3 11:53:39 05/02/14 Re: You say Wideband.. Only One? - Silens 12:06:58 05/02/14 Re: Re: You say Wideband.. Only One? - Cjw3 12:38:19 05/02/14 you should check your narrow bands - Zvil (FL) 00:38:26 05/03/14 Re: you should check your narrow bands - Cjw3 08:34:38 05/03/14 stock 02 sensors are used during closed loop only = idle (n/m) - The Devils Z 19:42:23 05/03/14 Re: stock 02 sensors are used during closed loop only = idle - Cjw3 23:13:17 05/03/14 you may be right -- it get it backwords - but they are only - The Devils Z 11:25:39 05/04/14 I believe initial start up until prescribed temp is open - SirpriZ 15:32:06 05/04/14 Idle is ALWAYS in Open Loop.. Read the Book (n/m) - Cjw3 16:39:08 05/04/14 my Z must have an abnormal quirk then - Zvil (FL) 16:52:50 05/05/14 "idle" is when the ECU sets the ignition timing at 15 - Cjw3 19:36:24 05/05/14 Depends on the tune....... - Greg D. (Specialty-Z) 17:48:12 05/06/14 Well, my 3 NA's are open loop at idle.. I've watched - Cjw3 20:42:14 05/06/14 If your running a factory tune........... - Greg D. (Specialty-Z) 21:06:03 05/06/14 mind = blown...I bow to the sensei :) (n/m) - Zvil (FL) 22:07:08 05/06/14 Very Nice.. - Cjw3 23:33:32 05/06/14 Look inside for post and u-tube by customer showing idle.... - Greg D. (Specialty-Z) 13:54:43 05/07/14
Post a Followup	You cannot reply to this message because you are not logged in.