Subject	Looks good to me
Posted by	SammybTT(TN) on April 27, 2014 at 9:45 PM
	This message has been viewed 185 times.
In Reply To	follow up on timing belt marks posted by Stanky on April 27, 2014 at 09:27 PM
Message	There is a procedure for rotating the belt in the FSM. If the tensioner distance changes you might need to adjust if it is not in specification. The last one I installed I had to go back and adjust the tensioner. If not 4mm I try to be on the lower side of the spec which allows for more travel when the belt stretches. Also you need to check the bely deflection between the gears along with the tensioner gap. Sounds like you are almost there. Good luck
Follow Ups	follow up on timing belt marks - Stanky 21:27:55 04/27/14 Looks good to me - SammybTT(TN) 21:45:27 04/27/14 Thanks! The FSM has some ridiculous procedures.. - Stanky 01:44:17 04/28/14 Removing the plugs just makes it easier to turn (n/m) - dvice 11:48:51 04/28/14
Post a Followup	You cannot reply to this message because you are not logged in.