Subject	As you increase Duty Cycle...
Posted by	-Grimm- on March 31, 2014 at 10:49 AM
	This message has been viewed 253 times.
In Reply To	Thank you. A little more, I use my controller on the posted by SirpriZ on March 27, 2014 at 04:41 PM
Message	(Corrected Table) the controller increases the duration of the 'open' portion of the solenoid. So I suppose it depends on if the solenoid is NO or NC (Normally Open, Normally Closed) with respect to the wastegate feed. If its NO, as you increase duty cycle you increase the time the solenoid is open (wastegate is not receiving a signal), increasing your boost level. (There is an optimum duty cycle point where you go from steady boost to boost spikes) I should have made the clarification, as I do not know which boost controllers are set up which way. Here is a table: Solenoid Setup Boost Level, 0% Duty Cycle Boost Level, 100% Duty Cycle Normally Open Wastegate Setting Infinite Boost (Damage) Normally Closed Infinite Boost (Damage) Wastegate Setting ------------------------------------------------------------------ 1992 300ZX NA 5 Sp (Dead) 1990 300ZX NA Auto 2+2 (Dead) 1990 300ZX TT 5 Sp (Building) 2004 G35 Sport 6MT (DD)
Follow Ups	Would someone in the know explain how duty cycle - SirpriZ 13:24:58 03/27/14 From my understanding... - -Grimm- 16:09:04 03/27/14 Thank you. A little more, I use my controller on the - SirpriZ 16:41:27 03/27/14 As you increase Duty Cycle... - -Grimm- 10:49:38 03/31/14 P.S. That helps explain how the gain setting works on my - SirpriZ 16:50:25 03/27/14 Idk about sirpriz's boost controller but mine works - Zvil (FL) 11:01:23 03/28/14 I appreciate the info. Mark (n/m) - SirpriZ 12:58:39 03/28/14 I deleted my post below. The mistake actually forced - SirpriZ 13:54:34 03/28/14 Post deleted below. If you want to correct table, - SirpriZ 16:52:46 03/30/14 Done and done. - -Grimm- 12:18:26 03/31/14 duty cycle refers to the pulse width modulated signal to the - aliaZ 12:06:00 03/28/14 Thanks Don. I think I have the basics. Mark (n/m) - SirpriZ 12:27:26 03/28/14
Post a Followup	You cannot reply to this message because you are not logged in.