Subject	Electronics Power Source
Posted by	ZXRider on March 20, 2014 at 11:55 AM
	This message has been viewed 231 times.
Message	Question about power source and current draw. I am going to install a Techtom-MDM100 that uses the Consult port. The unit receives its power from the port also. Currently I have a Greddy Profec B Spec 1 boost controller and it is tapped to the consult port for power. I am wondering if I might burn anything out or damage my ECU having too much draw from that port? Buy Zama Posters Here I have nightmares about that happening...I'd be the poor bastard you'd hear about on the news that gets killed by a softball-size chunk while spreading out my body over the hood and screaming "Nooo!" (Having a conversation about hail damage) - BradZ (FL) on March 25, 2005 at 9:56 PM Tell your friend that you could take a dump, light it on fire and that would be hotter shit than his car. Probes suck, that's just all there is to it. - 300ZXpert (someday) on April 04, 2005 at 11:35 PM P.S. You REALLY are on here at ALL hours! And I thought I was bad! :) - zmenon on August 16, 2005 at 3:06 AM LOL...2+2 drivers should grow mullets..."Business in the front...party in the back" ;) - BradZ (FL) on November 29, 2005 at 4:45 PM
Follow Ups	Electronics Power Source - ZXRider 11:55:39 03/20/14 Looking at the FSM... - f1ym4n 14:15:25 03/20/14 Thank you for your help - ZXRider 15:22:10 03/20/14 The MDM-100, about 1 amp. The boost controller, less than 3. (n/m) - DVDBURN (MD) 16:42:46 03/20/14 Hi Gary - ZXRider 17:40:29 03/20/14 I think you'll be fine. (n/m) - DVDBURN (MD) 17:57:29 03/20/14 Whats the worst damage I can do? - ZXRider 18:02:33 03/20/14 Yes. (n/m) - DVDBURN (MD) 23:21:29 03/20/14 draw a new line from the battery - fuzzymonkey 16:32:07 03/20/14 That sounds very nifty - ZXRider 17:41:45 03/20/14
Post a Followup	You cannot reply to this message because you are not logged in.