Subject	Re: Sending unit for fuel gauage in dash
Posted by	EmilZ on March 03, 2014 at 6:39 PM
	This message has been viewed 337 times.
In Reply To	Sending unit for fuel gauage in dash posted by Metacom on February 28, 2014 at 12:15 PM
Message	I've had to remove the fuel pump and clean the sending unit. The float is attached to a wiper that crosses a set of electrical pads on a circuit board. I used a pencil eraser to clean these contacts and my gauge starting working again.
Follow Ups	Sending unit for fuel gauage in dash - Metacom 12:15:50 02/28/14 There are two sending units. - DVDBURN (MD) 18:31:34 02/28/14 Good info - do you know if the 2+2 is setup the - jzack 18:59:03 02/28/14 Re: Sending unit for fuel gauage in dash - Eersfanpilot 22:41:40 02/28/14 Re: Re: Sending unit for fuel gauage in dash - Metacom 00:48:41 03/02/14 Re: Re: Re: Sending unit for fuel gauage in dash - Eersfanpilot 14:36:28 03/04/14 Re: Sending unit for fuel gauage in dash - EmilZ 18:39:20 03/03/14
Post a Followup	You cannot reply to this message because you are not logged in.