Subject	Re: CZP HICAS rod end conversion.
Posted by	The Sixth on February 20, 2014 at 3:52 PM
	This message has been viewed 185 times.
In Reply To	CZP HICAS rod end conversion. posted by YlwPrlZTT on February 20, 2014 at 02:23 PM
Message	Unless you're planning on removing the knuckle, you're going to want a pitman puller to remove the ball joint and a ball joint press to get the new bushing in. You can rent both from Autozone.
Follow Ups	CZP HICAS rod end conversion. - YlwPrlZTT 14:23:31 02/20/14 Re: CZP HICAS rod end conversion. - The Sixth 15:52:31 02/20/14 Will a c clamp work instead of the ball joint press? It seem - YlwPrlZTT 08:35:00 02/21/14 Not as easy but yes it will. I have used a C-clamp before. (n/m) - Woody75 (Denver) 09:26:13 02/21/14 Like Woody says, you CAN use one... - The Sixth 10:16:51 02/21/14 Great, thanks for the help. I will rent one out then. (n/m) - YlwPrlZTT 11:35:29 02/21/14 Free until you break it! (n/m) - WhiTTe Z (NY) 17:27:07 02/21/14
Post a Followup	You cannot reply to this message because you are not logged in.