Subject	Get ECU talk and a Consult cable
Posted by	Cjw3 on February 13, 2014 at 11:06 PM
	This message has been viewed 689 times.
In Reply To	code 53 running out of ideas posted by TurbodreamZ on February 13, 2014 at 08:39 PM
Message	[ http://www.ebay.com/itm/Diagnostic-Interface-for-14pin-RS232-Cable-Consult-Port-for-Nissan-vehicles-Seat-/330900689074?pt=Motors_Automotive_Tools&hash=item4d0b37d0b2&vxp=mtr ] Have a look and see what the O2 Sensor sig looks like.. Don't remember where I got ECU talk.. Someone here should have a link.. Or try the Google Machine Cj
Follow Ups	code 53 running out of ideas - TurbodreamZ 20:39:15 02/13/14 Get ECU talk and a Consult cable - Cjw3 23:06:46 02/13/14 I purchased the exact cable from the same seller. - SammybTT(TN) 22:25:59 02/14/14 Re: I purchased the exact cable from the same seller. - TurbodreamZ 01:05:15 02/15/14 Ok I understand your question now - SammybTT(TN) 09:38:28 02/15/14 Yep.. that is about what you are looking for - Cjw3 11:41:08 02/15/14 Re: Ok I understand your question now - TurbodreamZ 14:12:07 02/15/14 First Gauge of the four is running rich. most of the time - Cjw3 17:28:18 02/15/14 Could a bad pcv valve cause this? - TurbodreamZ 10:12:25 02/16/14 Forgot to mention it is not good to run the O2 unplugged. - SammybTT(TN) 10:33:37 02/15/14 Re: Forgot to mention it is not good to run the O2 unplugged. - TurbodreamZ 16:03:07 02/18/14 Sounds like it's not in Idle Mode. - Cjw3 20:22:57 02/18/14 It does idle properly. (n/m) - TurbodreamZ 22:26:46 02/18/14
Post a Followup	You cannot reply to this message because you are not logged in.