Subject	I used a race puller plate.
Posted by	xpwarrior on February 03, 2014 at 5:10 PM
	This message has been viewed 164 times.
In Reply To	Getting wheel hub out of bearing/knuckle assembly? posted by lazer(NJ) on February 03, 2014 at 08:00 AM
Message	I first cut the dust shield off then slipped the race puller in from each side. I then set 2 press plates on end then positioned the race puller on top and the hub pressed right out. I'm doing bearing replacement right now to. One side done.
Follow Ups	Getting wheel hub out of bearing/knuckle assembly? - lazer(NJ) 08:00:51 02/03/14 Kinda solution - lazer(NJ) 09:10:43 02/03/14 You have to hammer the living hell out of it - ZXRider 11:46:18 02/03/14 I used a race puller plate. - xpwarrior 17:10:41 02/03/14 6lb sledge got it the rest of the way out. (n/m) - lazer(NJ) 14:25:47 02/04/14
Post a Followup	You cannot reply to this message because you are not logged in.