Subject	Kinda solution
Posted by	lazer(NJ) on February 03, 2014 at 9:10 AM
	This message has been viewed 176 times.
In Reply To	Getting wheel hub out of bearing/knuckle assembly? posted by lazer(NJ) on February 03, 2014 at 08:00 AM
Message	I used a bearing race puller (big one) to brace the arbor plates against the press surface so the hub was off the surface. I've got it about half the way out. Trying a sledge hammer next. width=400 height=102> "The 300ZX Turbo is a dance; it's a song; it's rolling, roaring automotive art. There is no color that doesn't suit it. There is no mood-lifting chemical substance it can't replace." - Automobile Magazine
Follow Ups	Getting wheel hub out of bearing/knuckle assembly? - lazer(NJ) 08:00:51 02/03/14 Kinda solution - lazer(NJ) 09:10:43 02/03/14 You have to hammer the living hell out of it - ZXRider 11:46:18 02/03/14 I used a race puller plate. - xpwarrior 17:10:41 02/03/14 6lb sledge got it the rest of the way out. (n/m) - lazer(NJ) 14:25:47 02/04/14
Post a Followup	You cannot reply to this message because you are not logged in.