Subject	Sadly I don't have access to an old drive shaft to cut
Posted by	ZXRider on January 14, 2014 at 3:21 PM
	This message has been viewed 123 times.
In Reply To	I cut an old driveshaft and used that (n/m) posted by itsa300zx on January 14, 2014 at 02:46 PM
Message	If I knew the dimensions I'm sure I could order a cap of some sort from McMaster. Buy Zama Posters Here I have nightmares about that happening...I'd be the poor bastard you'd hear about on the news that gets killed by a softball-size chunk while spreading out my body over the hood and screaming "Nooo!" (Having a conversation about hail damage) - BradZ (FL) on March 25, 2005 at 9:56 PM Tell your friend that you could take a dump, light it on fire and that would be hotter shit than his car. Probes suck, that's just all there is to it. - 300ZXpert (someday) on April 04, 2005 at 11:35 PM P.S. You REALLY are on here at ALL hours! And I thought I was bad! :) - zmenon on August 16, 2005 at 3:06 AM LOL...2+2 drivers should grow mullets..."Business in the front...party in the back" ;) - BradZ (FL) on November 29, 2005 at 4:45 PM
Follow Ups	Cap for the transmission output shaft - ZXRider 12:00:26 01/14/14 The manual transmission has this same issue...... - SammybTT(TN) 12:29:53 01/14/14 I cut an old driveshaft and used that (n/m) - itsa300zx 14:46:45 01/14/14 Sadly I don't have access to an old drive shaft to cut - ZXRider 15:21:52 01/14/14 od of the shaft is 1.652"(41.95mm) x about 1/8" thickness (n/m) - itsa300zx 21:21:31 01/14/14 Awesome. Thank you very much. - ZXRider 22:12:00 01/14/14 the shinny polished part that goes in the rear trans seal - itsa300zx 22:24:22 01/14/14 Thank you very much - ZXRider 23:56:13 01/14/14
Post a Followup	You cannot reply to this message because you are not logged in.