Subject	I cut an old driveshaft and used that (n/m)
Posted by	itsa300zx on January 14, 2014 at 2:46 PM
	This message has been viewed 133 times.
In Reply To	Cap for the transmission output shaft posted by ZXRider on January 14, 2014 at 12:00 PM
Message
Follow Ups	Cap for the transmission output shaft - ZXRider 12:00:26 01/14/14 The manual transmission has this same issue...... - SammybTT(TN) 12:29:53 01/14/14 I cut an old driveshaft and used that (n/m) - itsa300zx 14:46:45 01/14/14 Sadly I don't have access to an old drive shaft to cut - ZXRider 15:21:52 01/14/14 od of the shaft is 1.652"(41.95mm) x about 1/8" thickness (n/m) - itsa300zx 21:21:31 01/14/14 Awesome. Thank you very much. - ZXRider 22:12:00 01/14/14 the shinny polished part that goes in the rear trans seal - itsa300zx 22:24:22 01/14/14 Thank you very much - ZXRider 23:56:13 01/14/14
Post a Followup	You cannot reply to this message because you are not logged in.