Subject	The manual transmission has this same issue......
Posted by	SammybTT(TN) on January 14, 2014 at 12:29 PM
	This message has been viewed 157 times.
In Reply To	Cap for the transmission output shaft posted by ZXRider on January 14, 2014 at 12:00 PM
Message	found this out when my transmission jack bleed down overnight which lowered the rear end of my transmission and allowed the fresh Redline fluid to flood my garage floor. This last time I removed the transmission I didn't take a chance and just stuck the drive shaft back into the transmission and put both to the side until I was ready for installation. This saved my time and money trying to locate a plug as well as saved me from purchasing another 3 liters of Redline. I am sure the more experienced guys will have good information/recommendation for a plug. Good luck
Follow Ups	Cap for the transmission output shaft - ZXRider 12:00:26 01/14/14 The manual transmission has this same issue...... - SammybTT(TN) 12:29:53 01/14/14 I cut an old driveshaft and used that (n/m) - itsa300zx 14:46:45 01/14/14 Sadly I don't have access to an old drive shaft to cut - ZXRider 15:21:52 01/14/14 od of the shaft is 1.652"(41.95mm) x about 1/8" thickness (n/m) - itsa300zx 21:21:31 01/14/14 Awesome. Thank you very much. - ZXRider 22:12:00 01/14/14 the shinny polished part that goes in the rear trans seal - itsa300zx 22:24:22 01/14/14 Thank you very much - ZXRider 23:56:13 01/14/14
Post a Followup	You cannot reply to this message because you are not logged in.