Subject	Fixxed!!!
Posted by	Basedd_z32tt on January 12, 2014 at 2:03 AM
	This message has been viewed 327 times.
In Reply To	Clutch looses pressure once Car is on posted by Basedd_z32tt on January 10, 2014 at 06:20 PM
Message	Thanks everyone for their input. First I adjusted pedal height Then I bled the clutch master cylinder by unplugging the line, holding hole with my finger and bleeding it with 4 pumps and holding down pressure until I conneted the line back again. Then I bled normally and voila that ish was done. Thankfully I did not have to remove the clutch booster and had time to work on my other Z :)
Follow Ups	Clutch looses pressure once Car is on - Basedd_z32tt 18:20:40 01/10/14 I don't have a lot of experience troubleshooting clutches - SammybTT(TN) 19:06:34 01/10/14 I drove it when it had the OEM clutch line - Basedd_z32tt 19:17:55 01/10/14 check your pushrod length - aliaZ 19:47:27 01/10/14 I have the same issue. - WhiTTe Z (NY) 08:43:18 01/11/14 Re: I have the same issue. - Basedd_z32tt 02:07:13 01/12/14 I will try that. - WhiTTe Z (NY) 13:02:43 01/12/14 Re: I will try that. - Basedd_z32tt 15:02:37 01/12/14 Sounds like your reaction disk inside the clutch booster - Joe@ZSpeedperformance 20:05:16 01/11/14 Re: Clutch looses pressure once Car is on - BlackTwins 00:56:13 01/12/14 Re: Clutch looses pressure once Car is on - BlackTwins 00:58:37 01/12/14 Fixxed!!! - Basedd_z32tt 02:03:41 01/12/14 Good deal, glad it is resolved. (n/m) - SammybTT(TN) 09:03:15 01/12/14
Post a Followup	You cannot reply to this message because you are not logged in.