Subject	for the timing, check the CAS and connectors.
Posted by	Medallion Man on January 06, 2014 at 2:40 AM
	This message has been viewed 214 times.
In Reply To	Need some help on a O2, Idle issue. posted by Woody75 (Denver) on January 05, 2014 at 09:44 PM
Message	I would do a full electrical check, clean and check all connectors, ensure good contact and all clips are on OK. make sure the ecu connector hasn't been overtightened and none of the pins have been pushed out. best of luck.
Follow Ups	Need some help on a O2, Idle issue. - Woody75 (Denver) 21:44:35 01/05/14 for the timing, check the CAS and connectors. - Medallion Man 02:40:53 01/06/14 The timing issue I saw was for the ecu timing, not CAS. - Woody75 (Denver) 09:22:18 01/06/14 Sounds like their is an issue with the idle valve, or the - ZaXxon 08:44:16 01/06/14 No air leaks, did the tests for that. - Woody75 (Denver) 09:28:42 01/06/14 Your O2 issue is a puzzler.. - doug8867 08:55:16 01/06/14 I traced all 3 wires for each O2. - Woody75 (Denver) 09:19:20 01/06/14 Thanks for the help so far guys, keep the ideas coming. (n/m) - Woody75 (Denver) 09:31:59 01/06/14 Re: Need some help on a O2, Idle issue. - hopester 13:25:57 01/06/14 Engine temp sensor is new so that's out. - Woody75 (Denver) 13:45:27 01/06/14 electrical gremlins - 300ZMang 20:07:09 01/06/14 I already tried a different ecu. No change. - Woody75 (Denver) 20:51:02 01/06/14 It sounds like you have covered the bases well - SammybTT(TN) 20:59:44 01/06/14 Regarding the idle not changing when adjusting in software.. - Evan_Wright (Ca) 21:40:12 01/06/14 Ecu is deff good. I took it out of one of my other z's. - Woody75 (Denver) 23:42:25 01/06/14 So here's what I found and did to fix it/figure it out - Woody75 (Denver) 23:56:14 01/06/14 Timing issue could be a normal ECU behaviour - zromtech 14:33:39 01/07/14
Post a Followup	You cannot reply to this message because you are not logged in.