Subject	Mine did the same
Posted by	-Grimm- on December 17, 2013 at 9:04 AM
	This message has been viewed 126 times.
In Reply To	Pin was indeed broken. posted by dvice on December 16, 2013 at 10:15 PM
Message	I put a dot on the CAS shaft and one on the exhaust cam sprocket with a sharpie (which ends up being right between the two bolts) to align it when putting it together. The drive teeth on both had no wear at all, so I figure someone installed it incorrectly at some point and forced it on. ------------------------------------------------------------------ 1992 300ZX NA 5 Sp (Dead) 1990 300ZX NA Auto 2+2 (Dead) 1990 300ZX TT 5 Sp (Building) 2004 G35 Sport 6MT (DD)
Follow Ups	New longblock won't start - dvice 22:53:04 12/14/13 I can't say for sure.. however.. - Medallion Man 02:02:04 12/15/13 Solution inside: - dvice 14:02:06 12/15/13 Ignore that - dvice 14:03:20 12/16/13 How far? - -Grimm- 14:13:22 12/16/13 Pin was indeed broken. - dvice 22:15:15 12/16/13 Mine did the same - -Grimm- 09:04:52 12/17/13 Thanks for the follow up. - Woody75 (Denver) 16:51:00 12/17/13 I knew one of us was very confused lol (n/m) - Brad(RI) 22:22:34 12/18/13
Post a Followup	You cannot reply to this message because you are not logged in.