Subject	Pin was indeed broken.
Posted by	dvice on December 16, 2013 at 10:15 PM
	This message has been viewed 209 times.
In Reply To	How far? posted by -Grimm- on December 16, 2013 at 02:13 PM
Message	I took off CAS mounting to get to a washer that fell and got stuck, and the only way I suspected CAS was because I noticed the pin was broken. I aligned CAS by looking at the remnants of the pin on the motor and where it "would have" went into the CAS and put it back on, started right away. I set timing to 15 after that and runs perfectly now.
Follow Ups	New longblock won't start - dvice 22:53:04 12/14/13 I can't say for sure.. however.. - Medallion Man 02:02:04 12/15/13 Solution inside: - dvice 14:02:06 12/15/13 Ignore that - dvice 14:03:20 12/16/13 How far? - -Grimm- 14:13:22 12/16/13 Pin was indeed broken. - dvice 22:15:15 12/16/13 Mine did the same - -Grimm- 09:04:52 12/17/13 Thanks for the follow up. - Woody75 (Denver) 16:51:00 12/17/13 I knew one of us was very confused lol (n/m) - Brad(RI) 22:22:34 12/18/13
Post a Followup	You cannot reply to this message because you are not logged in.