Subject	'Hard Break In' doesn't have to occur at a distinct point
Posted by	-Grimm- on December 12, 2013 at 12:41 PM
	This message has been viewed 209 times.
In Reply To	That's the hard break-in. Would have been ideal, but... posted by ThisIsSparTTa on December 12, 2013 at 11:40 AM
Message	as long as its within the first few hundred miles. For future reference. Also, you said the marks are long gone from your belt, which means you reused the old belt. Definitely should verify your timing, and replace the belt while you're in there (cheap insurance) ------------------------------------------------------------------ 1992 300ZX NA 5 Sp (Dead) 1990 300ZX NA Auto 2+2 (Dead) 1990 300ZX TT 5 Sp (Building) 2004 G35 Sport 6MT (DD)
Follow Ups	Is my rebuild borked? Ideas, please - ThisIsSparTTa 21:36:19 12/05/13 Confirm your timing belt is set correctly - ttsmokin 22:11:19 12/05/13 Can I run compression test while working on timing belt? - ThisIsSparTTa 07:55:15 12/06/13 Yeah you can - -Grimm- 09:00:07 12/06/13 If you are doing a compression test only, leave the cas - Krazyd27(Houston) 10:48:24 12/06/13 now would be a good time for a leak down test (n/m) - aliaZ 22:19:37 12/06/13 Re: Is my rebuild borked? Ideas, please - MaxxAction 16:02:07 12/07/13 WOT, charged battery, no plugs in. Could be my tester? (n/m) - ThisIsSparTTa 08:35:25 12/08/13 that isn't right - aliaZ 17:42:58 12/08/13 Re: that isn't right - MaxxAction 08:49:59 12/09/13 FWIW - aliaZ 12:53:46 12/09/13 Kyle's builds are supposed to give you between 120-140 psi - Stanky 21:34:41 12/07/13 I agree with ttsmokin, count the timing belt teeth - ZaXxon 04:27:09 12/08/13 Re: Is my rebuild borked? Ideas, please - WazTTed 14:40:21 12/08/13 No safety boost solenoids. No codes. New det sensor (n/m) - ThisIsSparTTa 08:19:49 12/09/13 Re: Is my rebuild borked? Ideas, please - coreymbassett 07:57:11 12/10/13 It wasn't the 'hard break in' - ThisIsSparTTa 12:12:27 12/10/13 Re: It wasn't the 'hard break in' - MaxxAction 10:22:26 12/11/13 I'm not sure of any 'best' break in practice - -Grimm- 10:35:04 12/11/13 10W-30 Dino, Other work I did... - ThisIsSparTTa 11:39:33 12/12/13 That's the hard break-in. Would have been ideal, but... - ThisIsSparTTa 11:40:55 12/12/13 'Hard Break In' doesn't have to occur at a distinct point - -Grimm- 12:41:12 12/12/13 Some Updates - ThisIsSparTTa 08:52:44 01/02/14
Post a Followup	You cannot reply to this message because you are not logged in.